Zte ZXHN H3601 - Configure the Netsphere

6 Configure the Local Network
6.10 Configure the NetSphere
The section describes how to set the device role in the mesh network.
Steps
1. In the left navigation tree, click Local Network > NetSphere to the NetSphere page,
see Figure 6-30.
Figure 6-30 NetSphere page
2. Set the device role in the mesh network. For a description of the parameters, refer to
Table 6-20.
Table 6-20 Parameter Descriptions for the NetSphere
Parameter Description
Enable Click On button to enable the multi-AP networking function.Click Off button,
the device is used as a common wireless router.
Mode Setting the Device Role in the mesh Network.
 Controller: set the device as the main control AP in the mesh network and
connects the LAN interface of the optical cat.
 Agent: set the device as subordinate AP in the mesh network to connect
the WAN interface of the main control AP.
3. Click Apply button to apply the changes.
SJ-20200429083356-004 | 2020-07-23(R1.0) 6-25