Chapter 6 Monitor
ZyWALL ATP Series User’s Guide
133
6.11 The UPnP Port Status Screen
Use this screen to look at the NAT port mapping rules that UPnP creates on the Zyxel Device. To access
this screen, click Monitor > System Status >
UPnP Port Status.
Figure 108 Monitor > System Status > UPnP Port Status
The following table describes the labels in this screen.
Cellular System This field displays what type of cellular network the mobile broadband connection is
using. The network type varies depending on the mobile broadband card you inserted
and could be UMTS, UMTS/HSDPA, GPRS or EDGE when you insert a GSM mobile
broadband card, or 1xRTT, EVDO Rev.0 or EVDO Rev.A when you insert a CDMA mobile
broadband card.
Signal Strength This is the Signal Quality measured in dBm.
Signal Quality This displays the strength of the signal. The signal strength mainly depends on the
antenna output power and the distance between your Zyxel Device and the service
provider’s base station.
Device Manufacturer This shows the name of the company that produced the mobile broadband device.
Device Model This field displays the model name of the cellular card.
Device Firmware This shows the software version of the mobile broadband device.
Device IMEI/ESN IMEI (International Mobile Equipment Identity) is a 15-digit code in decimal format that
identifies the mobile broadband device.
ESN (Electronic Serial Number) is an 8-digit code in hexadecimal format that identifies
the mobile broadband device.
SIM Card IMSI IMSI (International Mobile Subscriber Identity) is a 15-digit code that identifies the SIM
card.
Table 37 Monitor > System Status > Cellular Status > More Information (continued)
LABEL DESCRIPTION
Table 38 Monitor > System Status > UPnP Port Status
LABEL DESCRIPTION
Remove Select an entry and click this button to remove it from the list.
# This is the index number of the UPnP-created NAT mapping rule entry.
To Next Page
Loading...
