Chapter 24 Web Authentication
ZyWALL ATP Series User’s Guide
461
Figure 322 Configuration > Web Authentication > SSO
The following table gives an overview of the objects you can configure.
24.4.3 Enable Web Authentication
Enable Web Authentication and add a web authentication policy.
Table 187 Configuration > Web Authentication > SSO
LABEL DESCRIPTION
Listen Port The default agent listening port is 2158. If you change it on the Zyxel Device, then
change it to the same number in the Gateway Port field on the SSO agent too. Type
a number ranging from 1025 to 65535.
Agent PreShareKey Type 8-32 printable ASCII characters or exactly 32 hex characters (0-9; a-f). The
Agent PreShareKey is used to encrypt communications between the Zyxel Device
and the SSO agent.
Primary Agent Type the IPv4 address of the SSO agent. The Zyxel Device and the SSO agent must
be in the same domain and be able to communicate with each other.
Primary Agent Port Type the same port number here as in the Agent Listening Port field on the SSO
agent. Type a number ranging from 1025 to 65535.
Secondary Agent Address
(Optional)
Type the IPv4 address of the backup SSO agent if there is one. The Zyxel Device and
the backup SSO agent must be in the same domain and be able to communicate
with each other.
Secondary Agent Port
(Optional)
Type the same port number here as in the Agent Listening Port field on the backup
SSO agent if there is one. Type a number ranging from 1025 to 65535.
Apply Click this button to save your changes to the Zyxel Device.
Reset Click this button to return the screen to its last-saved settings
To Next Page
Loading...
