Chapter 4 Quick Setup Wizards
ZyWALL ATP Series User’s Guide
72
Figure 50 Choose an Ethernet Interface
4.2.2 Select WAN Type
WAN Type Selection: Select the type of encapsulation this connection is to use. Choose Ethernet when
the WAN port is used as a regular Ethernet.
Otherwise, choose PPPoE, PPTP or L2TP for a dial-up connection according to the information from your
ISP.
Figure 51 WAN Interface Setup: Step 2
The screens vary depending on what encapsulation type you use. Refer to information provided by your
ISP to know what to enter in each field. Leave a field blank if you don’t have that information.
Note: Enter the Internet access information exactly as your ISP gave it to you.
4.2.3 Configure WAN IP Settings
Use this screen to select whether the interface should use a fixed or dynamic IP address.
To Next Page
Loading...
