ZyXEL Communications ATP200 - Chapter 3 Hardware, Interfaces and Zones; Hardware Overview; Front Panels

ZyWALL ATP Series User’s Guide
64
CHAPTER 3
Hardware, Interfaces and
Zones
3.1 Hardware Overview
This section describes the front and rear panels for each model.
3.1.1 Front Panels
The LED indicators are located on the front panel.
Figure 41 ATP200 Front Panel
Figure 42 ATP500 Front Panel
Figure 43 ATP800 Front Panel
The following table describes the front panel LEDs.
Table 10 LED Descriptions
LED COLOR STATUS DESCRIPTION
PWR Off The Zyxel Device is turned off.
Green On The Zyxel Device is turned on.
Red On There is a hardware component failure. Shut down the device, wait for a few
minutes and then restart the device. If the LED turns red again, then please
contact your vendor.