Chapter 34 Object
ZyWALL ATP Series User’s Guide
631
34.7.3 The Service Group Summary Screen
The Service Group summary screen provides a summary of all service groups. In addition, this screen
allows you to add, edit, and remove service groups.
To access this screen, log in to the Web Configurator, and click Configuration > Object > Service >
Service Group.
Figure 411 Configuration > Object > Service > Service Group
The following table describes the labels in this screen. See Section 34.7.3.1 on page 632 for more
information as well.
Table 267 Configuration > Object > Service > Service Group
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific service group.
Family This field displays the Server Group supported type, which is according to your configurations in
the Service Group Add/Edit screen.
There are 3 types of families:
• : Supports IPv4 only
• : Supports IPv6 only
• : Supports both IPv4 and IPv6
Name This field displays the name of each service group.
By default, the Zyxel Device uses services starting with “Default_Allow_” in the security policies
to allow certain services to connect to the Zyxel Device.
Description This field displays the description of each service group, if any.
Reference This displays the number of times an object reference is used in a profile.
To Next Page
Loading...
