Chapter 10 Routing
ZyWALL ATP Series User’s Guide
308
10.3 IP Static Route Screen
Click Configuration > Network > Routing > Static Route to open the Static Route screen. This screen
displays the configured static routes. Configure static routes to be able to use RIP or OSPF to propagate
the routing information to other routers. If you enabled IPv6 in the Configuration > System > IPv6 screen,
you can also configure static routes used for your IPv6 networks on this screen.
Figure 208 Configuration > Network > Routing > Static Route
The following table describes the labels in this screen.
10.3.1 Static Route Add/Edit Screen
Select a static route index number and click Add or Edit. The screen shown next appears. Use this screen
to configure the required information for a static route.
Table 122 Configuration > Network > Routing > Static Route
LABEL DESCRIPTION
IPv4 Configuration /
IPv6 Configuration
Use the IPv4 Configuration section for IPv4 network settings. Use the IPv6 Configuration
section for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both
sections have similar fields as described below.
Add Click this to create a new static route.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
# This is the number of an individual static route.
Destination This is the destination IP address.
Subnet Mask This is the IP subnet mask.
Prefix This is the IPv6 prefix for the destination IP address.
Next-Hop This is the IP address of the next-hop gateway or the interface through which the traffic is
routed. The gateway is a router or switch on the same segment as your Zyxel Device's
interface(s). The gateway helps forward packets to their destinations.
Metric This is the route’s priority among the Zyxel Device’s routes. The smaller the number, the
higher priority the route has.
To Next Page
Loading...
