Chapter 25 Security Policy
ZyWALL ATP Series User’s Guide
491
25.6 The Session Control Screen
Click Configuration > Security Policy > Session Control to display the Security Policy Session Control
screen. Use this screen to limit the number of concurrent NAT/Security Policy sessions a client can use.
You can apply a default limit for all users and individual limits for specific users, addresses, or both. The
individual limit takes priority if you apply both.
Figure 334 Configuration > Security Policy > Session Control
Log These are the log options. To edit this, select an item and use the Log icon.
Action This is the action the Zyxel Device should take when a packet matches a policy. To
edit this, select an item and use the Action icon.
OK Click OK to save your settings to the Zyxel Device, complete the profile and return to
the profile summary page.
Cancel Click Cancel to return to the profile summary page without saving any changes.
Save Click Save to save the configuration to the Zyxel Device but remain in the same
page. You may then go to the another profile screen (tab) in order to complete the
profile. Click OK in the final profile screen to complete the profile.
Table 195 Configuration > Security Policy > ADP > Profile > Add-Protocol-Anomaly
LABEL DESCRIPTION
To Next Page
Loading...
