ZyXEL Communications ATP200 - Page 40

Chapter 1 Introduction
ZyWALL ATP Series User’s Guide
40
Routing Policy Route Create and manage routing policies.
Static Route Create and manage IP static routing information.
RIP Configure device-level RIP settings.
OSPF Configure device-level OSPF settings, including areas and virtual links.
BGP Configure exchange of Border Gateway Protocol (BGP) information
over an IPSec tunnel.
DDNS DDNS Define and manage the Zyxel Device’s DDNS domain names.
NAT NAT Set up and manage port forwarding rules.
Redirect
Service
Redirect Service Set up and manage HTTP and SMTP redirection rules.
ALG ALG Configure SIP, H.323, and FTP pass-through settings.
UPnP UPnP Configure interfaces that allow UPnP and NAT-PMP connections.
IP/MAC Binding Summary Configure IP to MAC address bindings for devices connected to each
supported interface.
Exempt List Configure ranges of IP addresses to which the Zyxel Device does not
apply IP/MAC binding.
Layer 2 Isolation General Enable layer-2 isolation on the Zyxel Device and the internal
interface(s).
White List Enable and configure the white list.
DNS Inbound LB DNS Load Balancing Configure DNS Load Balancing.
IPnP IPnP Enable IPnP on the Zyxel Device and the internal interface(s).
VPN
IPSec VPN VPN Connection Configure IPSec tunnels.
VPN Gateway Configure IKE tunnels.
Concentrator Combine IPSec VPN connections into a single secure network
Configuration
Provisioning
Set who can retrieve VPN rule settings from the Zyxel Device using the
Zyxel Device IPSec VPN Client.
SSL VPN Access Privilege Configure SSL VPN access rights for users and groups.
Global Setting Configure the Zyxel Device’s SSL VPN settings that apply to all
connections.
L2TP VPN L2TP VPN Configure L2TP over IPSec tunnels.
BWM BWM Enable and configure bandwidth management rules.
Web
Authentication
Web Authentication
General/
Authentication
Type/Custom Web
Portal File/Custom
User Agreement File
Define a web portal and exempt services from authentication.
SSO Configure the Zyxel Device to work with a Single Sign On agent.
Security Policy
Policy Control Policy Create and manage level-3 traffic rules and apply Security Service
profiles.
ADP General Display and manage ADP bindings.
Profile Create and manage ADP profiles.
Session Control Session Control Limit the number of concurrent client NAT/security policy sessions.
Table 7 Configuration Menu Screens Summary (continued)
FOLDER OR LINK TAB FUNCTION