ZyXEL Communications LTE7460-M608 - Adding Devices to Your Static DHCP List

Chapter 3 Tutorials
LTE7460-M608 User’s Guide
18
through a DHCP Ack (Acknowledge) message that the host can use the IP address for the previously
specified lease time.
To configure the DHCP in your LTE7460-M608:
1 Log into the LTE7460-M608’s Web Configurator.
2 Click Home Network > DHCP > DHCP Settings.
3 Click Enable DHCP Server.
4 Enter a range of addresses from which your DHCP will assign to devices in your network.
Note: Do not include the LTE7460-M608’s LAN IP address in your range of addresses.
5 Enter the Lease Time, the period of time (in minutes) a device can use one of the IP addresses from the
DHCP pool. The lease time helps recycle unused IP addresses so that other can use them again.
3.3.1 Adding Devices to Your Static DHCP List
IP addresses from the DHCP pool can be reused after they have completed their lease time. Add your
devices to your Static DHCP List so they have the same IP address everytime they connect to your
network.
To add a device to your Static DHCP List:
1 Log into the LTE7460-M608’s Web Configurator.
2 Click Home Network > DHCP > Static DHCP List.
3 Click Add New.
4 Enter the IP address you want to assign to your device.
5 Enter the MAC Address of your device to which the LTE7460 assigns the IP address.