Chapter 7 Networking
LTE7460-M608 User’s Guide
72
7.12 VPN Pass Through Screen
Click Networking > VPN Pass Through to open the following screen. Use this screen to enable different
types of VPN pass through so that VPN traffic can be sent through the LTE7460-M608.
Figure 57 Networking > VPN Pass Through
The following table describes the labels in this screen.
Table 26 Networking > VPN Pass Through
LABEL DESCRIPTION
VPN Pass Through
PPTP Pass Through Select Enable to allow VPN clients to make outbound PPTP connections. It is required
in order to connect to a PPTP VPN account. If PPTP is disabled, then when a client
sends a request to a VPN server, the server will reply to the LTE7460-M608 and the
LTE7460-M608 will drop the request. When PPTP is enabled, the LTE7460-M608 will
forward the reply from the VPN server to the client that initiated the request, and the
connection will establish successfully.
IPSec Pass Through Select Enable to allow VPN clients to make outbound IPSec connections. It is
required in order to connect to a IPSec VPN account. If IPSEC is disabled, then when
a client sends a request to a VPN server, the server will reply to the LTE7460-M608 and
the LTE7460-M608 will drop the request. When IPSEC is enabled, the LTE7460-M608 will
forward the reply from the VPN server to the client that initiated the request, and the
connection will establish successfully.
L2TP Pass Through Select Enable to allow VPN clients to make outbound L2TP connections. It is required
in order to connect to a L2TP VPN account. If L2TP is disabled, then when a client
sends a request to a VPN server, the server will reply to the LTE7460-M608 and the
LTE7460-M608 will drop the request. When L2TP is enabled, the LTE7460-M608 will
forward the reply from the VPN server to the client that initiated the request, and the
connection will establish successfully.
Apply Click Apply to save your changes back to the LTE7460-M608.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
