Chapter 5 Internet
LTE7460-M608 User’s Guide
36
5.6 Network Selection Screen
This screen allows you to view available Public Land Mobile Networks (PLMNs) and select your preferred
network when the LTE7460-M608 is outside the geographical coverage area of the network to which
you are registered and roaming is enabled.
Click Internet > Network Selection. The screen appears as shown next.
Authentication Select the type of authentication method peers use to connect to the LTE7460-M608
in LTE connections.
In Password Authentication Protocol (PAP) peers identify themselves with a user
name and a password. In Challenge Handshake Authentication Protocol (CHAP)
additionally to user names and passwords the LTE7460-M608 sends regular
challenges to make sure an intruder has not replaced a peer. Otherwise you can
select Auto or None.
Username This field displays the user name in the profile.
Type the user name (of up to 31 printable ASCII characters).
Password This field displays the password in the profile.
Type the password (of up to 31 printable ASCII characters) associated with the user
name above.
PDP type Choose the Packet Data Protocol (PDP) type provided by your Internet service
provider.
MTU Specify the Maximum Transmission Unit (MTU) for each packet or frame sent in the
LTE7460-M608’s network.
Apply Click Apply to save your changes back to the LTE7460-M608.
Reset Click Reset to reload the previous configuration for this screen.
Table 9 Internet > APN Configuration
LABEL DESCRIPTION
To Next Page
Loading...
