Chapter 6 Home Network
LTE7460-M608 User’s Guide
42
Figure 23 Home Networking > LAN Setup
The following table describes the fields in this screen.
6.3 The DHCP Screen
The LTE7460-M608 has built-in DHCP server capability that assigns IP addresses to systems that support
DHCP client capability. Use this screen to enable the DHCP server. To access this screen, click Home
Network > DHCP.
Table 12 Home Networking > LAN IP
LABEL DESCRIPTION
LAN IP
Host Name This shows the default host name.
Enter a new host name for the LTE7460-M608 if you want to change it.
IP Address This shows the default LAN IP address.
Enter the new IP address for the LTE7460-M608’s LAN interface if you want to change it.
Subnet Mask This shows the default subnet mask.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Apply Click Apply to save your changes back to the LTE7460-M608.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
