Chapter 6 Home Network
LTE7460-M608 User’s Guide
44
6.4 The Static Route Screen
Use this screen to view and configure IP static routes on the LTE7460-M608. Click Home Network > Static
Route to open the following screen.
Figure 25 Home Network > Static Route
The following table describes the labels in this screen.
Table 14 Home Network > Static Route
LABEL DESCRIPTION
Static Route
Enable Static Route Select the check box to enable the static route on the LTE7460-M608.
Apply Click Apply to save your changes back to the LTE7460-M608.
Reset Click Reset to reload the previous configuration for this screen.
Static Route List
Add New Click Add New to set up a new static route on the LTE7460-M608.
# This field displays the index number of an individual static route.
Destination IP This field specifies the IP network address of the final destination. Routing is always
based on network number.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Interface This is the WAN interface through which the traffic is routed.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Metric This is the “cost” of transmission for routing purposes.
Action Click Edit to go to the screen where you can set up a static route on the LTE7460-
M608.
Click Delete to remove a static route from the LTE7460-M608.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
