Chapter 7 Networking
LTE7460-M608 User’s Guide
61
7.3 TR069 Screen
TR-069 defines how Customer Premise Equipment (CPE), for example your LTE7460-M608, can be
managed over the WAN by an Auto Configuration Server (ACS). TR-069 is based on sending Remote
Procedure Calls (RPCs) between an ACS and a client device. RPCs are sent in Extensible Markup
Language (XML) format over HTTP or HTTPS.
An administrator can use an ACS to remotely set up the LTE7460-M608, modify settings, perform firmware
upgrades as well as monitor and diagnose the LTE7460-M608. You have to enable the device to be
managed by the ACS and specify the ACS IP address or domain name and username and password.
Click Networking > TR069 to open the following screen. Use this screen to configure you LTE7460-M608 to
be managed by an ACS.
Enable Bridge Mode Select this check box to change the LTE7460-M608’s operating mode to Bridge
Mode.
Apply Click Apply to save your changes.
Reset Click Reset to restore your previously saved settings.
Table 17 Networking > Operating Mode
LABEL DESCRIPTION
To Next Page
Loading...
