Chapter 5 Internet
LTE7460-M608 User’s Guide
33
5.3 Internet Settings Screen
Use this screen to change your LTE7460-M608’s Internet access settings. Click Internet > Internet Settings.
The screen appears as shown next.
Figure 18 Internet > Internet Settings
The following table describes the labels in this screen.
5.4 PIN Settings Screen
Use this screen to turn on or off PIN code authentication on the inserted SIM Card. You can also change
your PIN code to prevent others from using your account should the SIM be stolen or removed from your
LTE7460-M608. Click Internet > PIN settings. The screen appears as shown next.
Table 7 Internet > Internet Settings
LABEL DESCRIPTION
Internet Settings
Allow Data Roaming Select this check box to enable data roaming on the LTE7460-M608.
Data roaming is to use your mobile device in an area which is not covered by your
local service provider. Enable data roaming to ensure that your LTE7460-M608 is kept
connected to the Internet when you are traveling outside the geographical
coverage area of the network to which you are registered.
Cellular Network Mode Select the type of the network (4G Mode, 3G Mode, or 2G Mode) to which you want
the LTE7460-M608 to connect.
Otherwise, select Auto to have the LTE7460-M608 connect to an available network
using the default settings on the SIM card. If the currently registered mobile network
is not available or the mobile network’s signal strength is too low, the LTE7460-M608
switches to another available mobile network.
Internet Connection
Method
Select Always to connect to the mobile network automatically if there is an
available mobile network. Otherwise, select Manual.
LTE Band Selection Select the LTE frequency bands provided by your ISP.
Apply Click Apply to save your changes back to the LTE7460-M608.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
