UAG CLI Reference Guide 110
CHAPTER 13
Zones
Set up zones to configure network security and network policies in the UAG.
13.1 Zones Overview
A zone is a group of interfaces and VPN tunnels. The UAG uses zones, not interfaces, in many
security and policy settings, such as firewall rules and remote management.
Zones cannot overlap. Each Ethernet interface, VLAN interface, bridge interface, PPPoE/PPTP
interface, and VPN tunnel can be assigned to at most one zone. Virtual interfaces are automatically
assigned to the same zone as the interface on which they run.
Figure 16 Example: Zones
To Next Page
Loading...
