Chapter 50 File Manager
UAG CLI Reference Guide
266
50.6.4 Command Line FTP Configuration File Download Example
The following example gets a configuration file named today.conf from the UAG and saves it on the
computer as current.conf.
Figure 26 FTP Configuration File Download Example
50.7 UAG File Usage at Startup
The UAG uses the following files at system startup.
Figure 27 UAG File Usage at Startup
1 The boot module performs a basic hardware test. You cannot restore the boot module if it is
damaged. The boot module also checks and loads the recovery image. The UAG notifies you if the
recovery image is damaged.
2 The recovery image checks and loads the firmware. The UAG notifies you if the firmware is
damaged.
C:\>ftp 192.168.1.1
Connected to 192.168.1.1.
220 FTP Server (UAG) [192.168.1.1]
User (192.168.1.1:(none)): admin
331 Password required for admin.
Password:
230 User admin logged in.
ftp> bin
200 Type set to I
ftp> cd conf
250 CWD command successful
ftp> get today.conf current.conf
200 PORT command successful
150 Opening BINARY mode data connection for conf/today.conf (20220
bytes)
226 Transfer complete.
ftp: 20220 bytes received in 0.03Seconds 652.26Kbytes/sec.
1. Boot Module
2. Recovery Image
3. Firmware
To Next Page
Loading...
