ZyXEL Communications UAG Series - Object Reference; Object Reference Commands; Chapter 3 Object Reference

UAG CLI Reference Guide 42
CHAPTER 3
Object Reference
This chapter describes how to use object reference commands.
3.1 Object Reference Commands
The object reference commands are used to see which configuration settings reference a specific
object. You can use this table when you want to delete an object because you have to remove
references to the object first.
Table 6 show reference Commands
COMMAND DESCRIPTION
show reference object username
[username]
Displays which configuration settings reference the specified user object.
show reference object address
[object_name]
Displays which configuration settings reference the specified address
object.
show reference object eps [object_name] Displays which configuration settings reference the specified endpoint
security object.
show reference object service
[object_name]
Displays which configuration settings reference the specified service
object.
show reference object schedule
[object_name]
Displays which configuration settings reference the specified schedule
object.
show reference object interface
[interface_name |
virtual_interface_name]
Displays which configuration settings reference the specified interface or
virtual interface object.
show reference object aaa authentication
[default | auth_method]
Displays which configuration settings reference the specified AAA
authentication object.
show reference object ca category
{local|remote} [cert_name]
Displays which configuration settings reference the specified
authentication method object.
show reference object account pppoe
[object_name]
Displays which configuration settings reference the specified PPPoE
account object.
show reference object account pptp
[object_name]
Displays which configuration settings reference the specified PPTP account
object.
show reference object sslvpn application
[object_name]
Displays which configuration settings reference the specified SSL VPN
application object.
show reference object crypto map
[crypto_name]
Displays which configuration settings reference the specified VPN
connection object.
show reference object isakmp policy
[isakmp_name]
Displays which configuration settings reference the specified VPN gateway
object.
show reference object sslvpn policy
[object_name]
Displays which configuration settings reference the specified SSL VPN
object.
show reference object zone [object_name] Displays which configuration settings reference the specified zone object.