ZyXEL Communications UAG Series - Dynamic-Guest Sub-Commands

Chapter 47 Dynamic Guest Accounts
UAG CLI Reference Guide
241
47.2.1 dynamic-guest Sub-commands
The following table describes the sub-commands for several dynamic-guest commands. Note that
not all rule commands use all the sub-commands listed here.
[no] dynamic-guest user_name Creates a dynamic guest account (billing-user) with the specified user
name and enters the dynamic-guest sub-command mode to set the
password and timeout settings. See Table 145 on page 241 for the sub-
commands.
The no command removes the specified dynamic-guest account.
show dynamic-guest log Displays all the dynamic guest accounts which are either active or expired.
show dynamic-guest log create-time
begin yyyy-mm-dd hh:mm end yyyy-mm-dd
hh:mm
Displays all the active and/or expired dynamic guest accounts that were
generated within a specified period of time.
show dynamic-guest users Displays all the active dynamic guest accounts on the UAG.
Table 144 dynamic-guest Commands (continued)
COMMAND DESCRIPTION
Table 145 dynamic-guest Sub-commands
COMMAND DESCRIPTION
charge price Sets the account’s price, up to 99999999.99, per time unit.
create-time yyyy-mm-dd hh:mm Sets the date and time the account is created.
expire-time yyyy-mm-dd hh:mm Sets the date and time the account becomes invalid.
password password Sets the password for the account.
payment-info {cash | payment-
service}
Sets the method of payment for the account.
phone phone_number Sets the mobile phone number for the account.
remaining-time <1..25920000> Sets the amount of Internet access time (in seconds) remaining for the
account.
time-period <1..432000> Sets the total account of time (in minutes) the account can use to access
the Internet through the UAG.