ZyXEL Communications UAG Series - Maximum Number of Managed Aps; Registration Commands (V2.50 Only)

Chapter 5 Registration
UAG CLI Reference Guide
48
5.2.2 Maximum Number of Managed APs
The UAG is initially configured to support up to one local AP and 8 remote managed APs (such as
the NWA5123-NI). You can increase this by subscribing to additional licenses. As of this writing,
each license upgrade allows an additional 8 remote managed APs while the maximum number of
remote managed APs a single UAG can support is 16.
5.3 Registration Commands (V2.50 Only)
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for registration. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 8 Input Values for General Registration Commands
LABEL DESCRIPTION
user_name The user name of your myZyXEL.com account. You must use six to 20 alphanumeric
characters (and the underscore). Spaces are not allowed.
password The password for the myZyXEL.com account. You must use six to 20 alphanumeric
characters (and the underscore). Spaces are not allowed.
Table 9 Command Summary: Registration
COMMAND DESCRIPTION
device-register checkuser user_name Checks if the user name exists in the myZyXEL.com
database.
device-register username user_name password password
[e-mail user@domainname] [country-code country_code]
[reseller-name name] [reseller-mail email-address]
[reseller-phone phone-number] [vat vat-number]
Registers the device with an existing account or creates a
new account and registers the device at one time.
country_code: see Table 11 on page 50
service-register checkexpire Gets information of all service subscriptions from
myZyXEL.com and updates the status table.
service-register service-type standard license-key
key_value
Activates a standard service subscription with the license
key.
service-register service-type trial service content-
filter
Activates the content filter trial service subscription.
show device-register status Displays whether the device is registered and account
information.
show service-register reseller-info Displays your seller’s information that you have entered
when registration.
show service-register server-type Displays the type of the register server to which your
UAG is connected.
show service-register status all Displays all service license information.
show service-register status content-filter Displays content filter service license information.