ZyXEL Communications UAG Series - 8.2 Interface General Commands Summary

Chapter 8 Interfaces
UAG CLI Reference Guide
70
* - You cannot set up a PPPoE/PPTP interface, virtual Ethernet interface, or virtual VLAN interface if the underlying
interface is a member of a bridge. You also cannot add an Ethernet interface or VLAN interface to a bridge if the
member interface has a virtual interface or PPPoE/PPTP interface on top of it.
8.2 Interface General Commands Summary
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following sections introduce commands that are supported by several types of interfaces.
virtual interface
(virtual Ethernet interface)
(virtual VLAN interface)
(virtual bridge interface)
Ethernet interface*
VLAN interface*
bridge interface
trunk Ethernet interface
VLAN interface
bridge interface
PPPoE/PPTP interface
Table 23 Relationships Between Different Types of Interfaces (continued)
INTERFACE REQUIRED PORT / INTERFACE
Table 24 Input Values for General Interface Commands
LABEL DESCRIPTION
interface_name The name of the interface.
Ethernet interface: The UAG715 and UAG5100 uses a name such as wan1, wan2, lan1,
lan2, or dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number of the
virtual interface. For example: lan1:y, y=1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 4
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces
your UAG model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge interface,
y = 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your UAG model supports.
profile_name The name of the DHCP pool. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
domain_name Fully-qualified domain name. You may up to 254 alphanumeric characters, dashes (-), or
periods (.), but the first character cannot be a period.