ZyXEL Communications UAG Series - 49.3 HTTP;HTTPS Commands

Chapter 49 System Remote Management
UAG CLI Reference Guide
250
49.2 Common System Command Input Values
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
49.3 HTTP/HTTPS Commands
The following table describes the commands available for HTTP/HTTPS. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 152 Input Values for General System Commands
LABEL DESCRIPTION
address_object The name of the IP address (group) object. You may use 1-31 alphanumeric
characters, underscores(
_), or dashes (-), but the first character cannot be a number.
This value is case-sensitive.
rule_number The number of a service control rule. 1 - X where X is the highest number of rules the
UAG model supports.
zone_object The name of the zone. Use up to 31 characters (a-zA-Z0-9_-). The name cannot start
with a number. This value is case-sensitive.
The UAG uses pre-defined zone names like DMZ, LAN1, LAN2, SSL VPN, IPSec VPN,
and WAN.
Table 153 Command Summary: HTTP/HTTPS
COMMAND DESCRIPTION
[no] ip http authentication auth_method Sets an authentication method used by the HTTP/HTTPS
server. The
no command resets the authentication
method used by the HTTP/HTTPS server to the factory
default (
default).
auth_method: The name of the authentication method.
You may use 1-31 alphanumeric characters,
underscores(_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
[no] ip http port <1..65535> Sets the HTTP service port number. The
no command
resets the HTTP service port number to the factory
default (80).
[no] ip http secure-port <1..65535> Sets the HTTPS service port number. The
no command
resets the HTTPS service port number to the factory
default (443).
[no] ip http secure-server Enables HTTPS access to the UAG web configurator. The
no command disables HTTPS access to the UAG web
configurator.
[no] ip http secure-server auth-client Sets the client to authenticate itself to the HTTPS server.
The
no command sets the client not to authenticate itself
to the HTTPS server.