UAG CLI Reference Guide 249
CHAPTER 49
System Remote Management
This chapter shows you how to determine which services/protocols can access which UAG zones (if
any) from which computers.
Note: To access the UAG from a specified computer using a service, make sure no
service control rules or to-Device firewall rules block that traffic.
49.1 Remote Management Overview
You may manage your UAG from a remote location via:
To disable remote management of a service, deselect Enable in the corresponding service screen.
49.1.1 Remote Management Limitations
Remote management will not work when:
1 You have disabled that service in the corresponding screen.
2 The accepted IP address in the Service Control table does not match the client IP address. If it
does not match, the UAG will disconnect the session immediately.
3 There is a firewall rule that blocks it.
49.1.2 System Timeout
There is a lease timeout for administrators. The UAG automatically logs you out if the management
session remains idle for longer than this timeout period. The management session does not time
out when a statistics screen is polling.
Each user is also forced to log in the UAG for authentication again when the reauthentication time
expires.
• Internet (WAN only) • ALL (LAN&WAN&DMZ)
•LAN only •DMZ only
To Next Page
Loading...
