Chapter 6 AP Management
UAG CLI Reference Guide
56
6.2.1 AP Management Commands Example
The following example shows you how to add an AP to the management list, and then edit it.
Router# show capwap ap wait-list
index: 1
IP: 192.168.1.35, MAC: 00:11:11:11:11:FE
Model: NWA5160N, Description: AP-00:11:11:11:11:FE
index: 2
IP: 192.168.1.36, MAC: 00:19:CB:00:BB:03
Model: NWA5160N, Description: AP-00:19:CB:00:BB:03
Router# configure terminal
Router(config)# capwap ap add 00:19:CB:00:BB:03
Router(config)# capwap ap 00:19:CB:00:BB:03
Router(AP 00:19:CB:00:BB:03)# slot1 ap-profile approf01
Router(AP 00:19:CB:00:BB:03)# exit
Router(config)# show capwap ap all
index: 1
Status: RUN
IP: 192.168.1.37, MAC: 40:4A:03:05:82:1E
Description: AP-404A0305821E
Model: NWA5160N
R1 mode: AP, R1Prof: default
R2 mode: AP, R2Prof: n/a
Station: 0, RadioNum: 2
Mgnt. VLAN ID: 1, Tag: no
WTP VLAN ID: 1, WTP Tag: no
Force VLAN: disable
Firmware Version: 2.25(AAS.0)b2
Recent On-line Time: 08:43:04 2013/05/24
Last Off-line Time: N/A
Router(config)# show capwap ap 40:4A:03:05:82:1E slot1 detail
index: 1
SSID: ZyXEL, BSSID: 40:4A:03:05:82:1F
SecMode: NONE, Forward Mode: Local Bridge, Vlan: 1
Router(config)# show capwap ap all statistics
index: 1
Status: RUN, Loading: -
AP MAC: 40:4A:03:05:82:1E
Radio: 1, OP Mode: AP
Profile: default, MAC: 40:4A:03:05:82:1F
Description: AP-404A0305821E
Model: NWA5160N
Band: 2.4GHz, Channel: 6
Station: 0
RxPkt: 4463, TxPkt: 38848
RxFCS: 1083323, TxRetry: 198478
To Next Page
Loading...
