ZyXEL Communications UAG Series - Page 55

Chapter 6 AP Management
UAG CLI Reference Guide
55
The following table describes the commands available for AP management. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 13 Command Summary: AP Management
COMMAND DESCRIPTION
capwap ap add ap_mac [ap_model] Adds the specified AP to the UAG for management. If manual add
is disabled, this command can still be used; if you add an AP
before it connects to the network, then this command simply
preconfigures the management list with that AP’s information.
capwap ap kick {all | ap_mac} Removes the specified AP (ap_mac) or all connected APs (all)
from the management list. Doing this removes the AP(s) from the
management list.
If the UAG is set to automatically add new APs to the AP
management list, then any kicked APs are added back to the
management list as soon as they reconnect.
capwap ap reboot ap_mac Forces the specified AP (ap_mac) to restart. Doing this severs the
connections of all associated stations.
capwap ap ap_mac Enters the sub-command mode for the specified AP.
slot_name ap-profile profile_name Sets the radio (slot_name) to AP mode and assigns a created
profile to the radio.
no slot_name ap-profile Removes the AP mode profile assignment for the specified radio
(slot_name).
description ap_description Sets the description for the specified AP.
[no] force vlan Sets whether or not the UAG changes the AP’s management VLAN
to match the one you configure using the vlan sub-command.
The management VLAN on the UAG and AP must match for the
UAG to manage the AP.
vlan <1..4094> {tag | untag} Sets the VLAN ID for the specified AP as well as whether packets
sent to and from that ID are tagged or untagged.
exit Exits the sub-command mode for the specified AP.
capwap manual-add {enable | disable} Allows the UAG to either automatically add new APs to the
network (disable) or wait until you manually confirm them
(enable).
capwap show statistic Displays statistics about the wireless radio transmitters in each of
the APs connected to the UAG.
capwap station kick sta_mac Forcibly disconnects the specified station from the network.
show capwap ap wait-list Displays a list of connected but as-of-yet unmanaged APs. This is
known as the ‘wait list’.
show capwap ap ap_mac slot_name detail Displays details for the specified radio (slot_name) on the
specified AP (ap_mac).
show capwap ap {all |
ap_mac} Displays the management list (all) or whether the specified AP is
on the management list (ap_mac).
show capwap ap {all | ap_mac} config status Displays whether or not any AP’s configuration or the specified
AP’s configuration is in conflict with the UAG’s settings for the AP
and displays the settings in conflict if there are any.
show capwap ap all statistics Displays radio statistics for all APs on the management list.
show capwap manual-add Displays the current manual add option.
show capwap station all Displays information for all stations connected to the APs on the
management list.