ZyXEL Communications UAG Series - Chapter 52 Reports and Reboot; 52.1 Report Commands Summary; 52.1.1 Report Commands

UAG CLI Reference Guide 277
CHAPTER 52
Reports and Reboot
This chapter provides information about the report associated commands and how to restart the
UAG using commands. It also covers the daily report e-mail feature.
52.1 Report Commands Summary
The following sections list the report, session, and packet size statistics commands.
52.1.1 Report Commands
This table lists the commands for reports.
Table 171 report Commands
COMMAND DESCRIPTION
[no] report Begins data collection. The no command stops data collection.
show report status Displays whether or not the UAG is collecting data and how long it has collected data.
clear report [interface_name] Clears the report for the specified interface or for all interfaces.
show report [interface_name
{ip | service | url}]
Displays the traffic report for the specified interface and controls the format of the
report. Formats are:
ip - traffic by IP address and direction
service - traffic by service and direction
url - hits by URL