ZyXEL Communications UAG Series - 7.3 SSID Profile Commands

Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
62
It will also assign the SSID profile labeled ‘default’ in order to create WLAN VAP (wlan-1-1)
functionality within the radio profile.
7.3 SSID Profile Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Router(config)# wlan-radio-profile RADIO01
Router(config-profile-radio)# activate
Router(config-profile-radio)# band 2.4G
Router(config-profile-radio)# 2g-channel 6
Router(config-profile-radio)# ch-width 20m
Router(config-profile-radio)# dtim-period 2
Router(config-profile-radio)# beacon-interval 100
Router(config-profile-radio)# ampdu
Router(config-profile-radio)# limit-ampdu 65535
Router(config-profile-radio)# subframe-ampdu 64
Router(config-profile-radio)# amsdu
Router(config-profile-radio)# limit-amsdu 4096
Router(config-profile-radio)# block-ack
Router(config-profile-radio)# guard-interval short
Router(config-profile-radio)# tx-mask 5
Router(config-profile-radio)# rx-mask 7
Router(config-profile-radio)# output-power 100%
Router(config-profile-radio)# ssid-profile 1 default
Table 16 Input Values for General SSID Profile Commands
LABEL DESCRIPTION
ssid_profile_name The SSID profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
ssid The SSID broadcast name. You may use 1-32 alphanumeric characters,
underscores (
_), or dashes (-). This value is case-sensitive.
wlan_qos Sets the type of QoS the SSID should use.
disable: Turns off QoS for this SSID.
wmm: Turns on QoS for this SSID. It automatically assigns Access Categories to
packets as the device inspects them in transit.
wmm_be: Assigns the “best effort” Access Category to all traffic moving through
the SSID regardless of origin.
wmm_bk: Assigns the “background” Access Category to all traffic moving through
the SSID regardless of origin.
wmm_vi: Assigns the “video” Access Category to all traffic moving through the
SSID regardless of origin.
wmm_vo: Assigns the “voice” Access Category to all traffic moving through the
SSID regardless of origin.
vlan_iface The VLAN interface name of the controller (in this case, it is NXC5200). The
maximum VLAN interface number is product-specific; for the UAG, the number
is 512.
securityprofile Assigns an existing security profile to the SSID profile. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.