ZyXEL Communications UAG Series - Page 63

Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
63
The following table describes the commands available for SSID profile management. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
macfilterprofile Assigns an existing MAC filter profile to the SSID profile. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
description2 Sets the description of the profile. You may use up to 60 alphanumeric
characters, underscores (
_), or dashes (-). This value is case-sensitive.
Table 16 Input Values for General SSID Profile Commands (continued)
LABEL DESCRIPTION
Table 17 Command Summary: SSID Profile
COMMAND DESCRIPTION
show wlan-ssid-profile {all |
ssid_profile_name}
Displays the SSID profile(s).
all: Displays all profiles for the selected operating mode.
ssid_profile_name: Displays the specified profile for the
selected operating mode.
wlan-ssid-profile rename ssid_profile_name1
ssid_profile_name2
Gives an existing SSID profile (ssid_profile_name1) a new
name (ssid_profile_name2).
[no] wlan-ssid-profile ssid_profile_name Enters configuration mode for the specified SSID profile. Use the
no parameter to remove the specified profile.
[no] block-intra Enables intra-BSSID traffic blocking. Use the no parameter to
disable it in this profile.
By default this is disabled.
[no] hide Prevents the SSID from being publicly broadcast. Use the no
parameter to re-enable public broadcast of the SSID in this
profile.
By default this is disabled.
ssid Sets the SSID. This is the name visible on the network to wireless
clients. Enter up to 32 characters, spaces and underscores are
allowed.
The default SSID is ‘ZyXEL’.
qos wlan_qos Sets the type of QoS used by this SSID.
vlan-id <1..4094> Applies to each SSID profile that uses localbridge. If the VLAN
ID is equal to the AP’s native VLAN ID then traffic originating from
the SSID is not tagged.
The default VLAN ID is 1.
[no] vlan-support Sets the UAG to tag traffic from the local Virtual AP (VAP) with the
VLAN ID specified in this SSID profile.
The no command sets the UAG to not tag traffic from the local
Virtual AP (VAP) with the VLAN ID.
security securityprofile Assigns the specified security profile to this SSID profile.
[no] macfilter macfilterprofile Assigns the specified MAC filtering profile to this SSID profile. Use
the no parameter to remove it.
By default, no MAC filter is assigned.
exit Exits configuration mode for this profile.