ZyXEL Communications UAG Series - Printer-Manager Command Example; Printer-Manager Printer Sub-Commands

Chapter 30 Printer Manager
UAG CLI Reference Guide
165
30.2.1 Printer-manager Printer Sub-commands
The following table describes the sub-commands for the printer-manager printer command.
30.2.2 Printer-manager Command Example
This example adds a printer to the managed printer list and displays the printer settings.
show printer-manager printer [<1..10>] Displays settings of all or the specified printer that can be managed by the
UAG.
show printer-manager printer-status Displays information about the printers that are connected and can be
managed by the UAG.
show printer-manager printerfw version Displays the version of the printer firmware currently uploaded to the UAG.
The UAG automatically installs it in the connected printers to make sure the
printers are upgraded to the same version.
show printer-manager printout-type Displays the current account printout format.
show printer-manager settings Displays the printer management settings.
show printer-manager workableIP Displays the number and IP address(s) of printer(s) that can synchronize
with the UAG successfully.
Table 96 printer-manager Commands (continued)
COMMAND DESCRIPTION
Table 97 printer-manager printer Sub-commands
COMMAND DESCRIPTION
activate Enables the entry.
deactivate Disables the entry.
description description Sets a descriptive name for the printer.
printer-ip ipv4_address Sets the IP address of the printer.
Router# configure terminal
Router(config)# printer-manager printer 1
Router(printer-manager)# activate
Router(printer-manager)# description cafe
Router(printer-manager)# printer-ip 172.16.0.123
Router(printer-manager)# exit
Router(config)# show printer-manager printer
printer: 1
activate: yes
IPv4 address: 172.16.0.123
description: cafe
Router(config)#