UAG CLI Reference Guide 161
CHAPTER 29
Payment Service
29.1 Payment Service Overview
The online payment service allows users to purchase access time online with a credit card. You
must register with the supported credit card service before you can configure the UAG to handle
credit card transactions.
29.2 Payment-service Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table lists the payment-service commands. You must use the
configure
terminal
command to enter the configuration mode before you can use these commands.
Table 93 Input Values for payment-service Commands
LABEL DESCRIPTION
message A note that displays in a custom online payment service page. You may use up to
1024 printable ASCII characters. Spaces are allowed.
Table 94 payment-service Commands
COMMAND DESCRIPTION
payment-service account-delivery
onscreen {activate | deactivate}
Allows or disallows the UAG to display the user account information in the
web screen.
payment-service account-delivery sms
{activate | deactivate}
Allows or disallows the UAG to use Short Message Service (SMS) to send
account information in a text message to the user’s mobile device.
[no] payment-service activate Enables online payment service.
The no command disables online payment service.
payment-service check payment-all-
currency
Diaplays the name of online payment service provider and checks if the
currency unit for billing and the currency unit for online payment are the
same.
payment-service check payment-currency Checks if the currency unit for billing and the currency unit for online
payment are the same.
payment-service check paypal-currency Checks if the currency unit for billing and the currency unit for online
payment using PayPal are the same.
payment-service fail-page failed-
message message
Specifies a note to display when the user’s online payment failed.
To Next Page
Loading...
