ZyXEL Communications UAG Series - Page 173

Chapter 33 Bandwidth Management
UAG CLI Reference Guide
173
[no] service service-object {service_name |
any}
Specifies a service or service group to identify the type of
traffic to which this policy applies.
any: the policy is effective for every service.
The no command resets the service to the default (any).
show Displays the policy settings.
[no] source address_object Sets the source IP address or address group for whom this
policy applies.
The no command resets the source IP address(es) to the
default (any). any
means all IP addresses.
[no] type {per-user | shared} Sets the type of bandwidth management.
per-user: to allow every user that matches this policy to
use up to the bandwidth configured in this policy.
shared: to have users that match this policy to share the
bandwidth configured in this policy.
The no command resets the bandwidth management type
to the default (shared).
[no] user user_name Sets a user name or user group to which to apply the
policy.
The
no command resets the user name to the default
(any). any
means all users.
Table 101 bwm Sub-commands (continued)
COMMAND DESCRIPTION