Chapter 50 File Manager
UAG CLI Reference Guide
271
9 Enter “quit” to exit the ftp prompt.
Figure 38 FTP Firmware Transfer Complete
10 The console session displays “done” when the firmware recovery is complete. Then the UAG
automatically restarts.
Figure 39 Firmware Recovery Complete and Restart
11 The username prompt displays after the UAG starts up successfully. The firmware recovery process
is now complete and the UAG is ready to use.
Figure 40 Restart Complete
200 PORT command successful
150 Opening BINARY mode data connection for 250AACG0C0.bin
226-firmware verifying...
226-firmware updating...
226-Please Wait about 5 minutes!!
226-Do not poweroff or reset,
226-system will reboot automatically after finished updating.
226 Transfer complete.
ftp: 42923922 bytes sent in 3.50Seconds 12260.47Kbytes/sec.
ftp> quit
BM cmd line: console=ttyS0,115200 root=/dev/ram init=zyinit "-r /dev/sda", addre
ss: 0x100000
intird start:000000008425E000 size:00000000000EAF4E
vmlinux start:0000000084006000 size:00000000002575CD
Uncompressing Linux...done.
Start to check file system...
/dev/sda2: 30/17640 files (6.7% non-contiguous), 47365/70432 blocks
/dev/sda3: 96/112224 files (2.1% non-contiguous), 8231/224192 blocks
Done
INIT: version 2.86 booting
Initializing Debug Account Authentication Seed (DAAS)... done.
Setting the System Clock using the Hardware Clock as reference...System Clock se
INIT: Entering runlevel: 313:48:37 UTC 2012
Starting zylog daemon: zylogd zylog starts.
Starting syslog-ng.
Starting ZLD Wrapper Daemon....
Starting uam daemon.
Starting periodic command scheduler: cron.
Start UAG715 system daemon....
..........................
Got LINK_CHANGE
Port [1] Copper is up --> Group [1] is up
.......................
Got LINK_CHANGE
Port [2] Copper is up --> Group [2] is up
Applying system configuration file, please wait...
.Device system is configured successfully with startup-config.conf
Welcome to UAG715
Username:
To Next Page
Loading...
