Chapter 4 The Web Configurator
XGS1930 Series User’s Guide
42
After clicking Next, the Link Aggregation screen appears.
Figure 28 Wizard > Basic > Step 3 Link Aggregation
Each field is described in the following table.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNextrequests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or lower.
Set Community Enter the Set Community string, which is the password for the incoming Set- requests from
the management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or lower.
Trap Community Enter the Trap Community string, which is the password sent with each trap to the SNMP
manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or lower.
Previous Click Previous to show the previous screen.
Next Click Next to show the next screen.
Cancel Click Cancel to exit this screen without saving.
Table 8 Wizard > Basic > Step 3 Link Aggregation
LABEL DESCRIPTION
Link Aggregation
T1-T5 Click the arrows to add or delete icons located on the left to desired preference.
Select Static if the ports are configured as static members of a trunk group.
Select LACP if the ports are configured to join a trunk group via LACP.
Previous Click Previous to show the previous screen.
Table 7 Wizard > Basic > Step 2 Password
LABEL DESCRIPTION
To Next Page
Loading...
