Chapter 21 Classifier
XS1930 Series User’s Guide
180
Click Advanced Application > Classifier in the navigation panel to display the configuration screen as
shown.
Figure 130 Advanced Application > Classifier
The following table describes the labels in this screen.
21.3 Classifier Configuration
Use the Classifier Configuration screen to define the classifiers. After you define the classifier, you can
specify actions (or policy) to act upon the traffic that matches the rules. To configure policy rules, refer
to Chapter 22 on page 188.
In the Classifier Status screen click Classifier Configuration to display the configuration screen as shown.
Table 81 Advanced Application > Classifier
LABEL DESCRIPTION
Index This field displays the index number of the rule. Click an index number to edit the rule.
Active This field displays Yes when the rule is activated and No when it is deactivated.
Weight This field displays the rule’s weight. This is to indicate a rule’s priority when the match order is set
to manual in the Classifier > Classifier Configuration > Classifier Global Setting screen.
The higher the number, the higher the rule’s priority.
Name This field displays the descriptive name for this rule. This is for identification purpose only.
Match Count This field displays the number of times a rule is applied. It displays '-' if the rule does not have
count enabled.
Rule This field displays a summary of the classifier rule’s settings.
Clear Select Classifier, enter a classifier rule name and then click Clear to erase the recorded
statistical information for that classifier, or select Any to clear statistics for all classifiers.
To Next Page
Loading...
