Chapter 4 The Web Configurator
XS1930 Series User’s Guide
48
4.4 Wizard
The Setup Wizard contains the following parts:
• Basic - to configure the Switch IP address, DNS server, system password, SNMP community, and link
aggregation (trunking).
• Protection - to enable loop guard and broadcast storm on the Switch and its ports.
• VLAN - to create a static VLAN, assign ports to the VLAN, and set the ports to tag or untag outgoing
frames.
• QoS - to determine a port’s IEEE 802.1p priority level for QoS.
4.4.1 Basic
In Basic, you can set up IP/DNS, set up your password, SNMP community, link aggregation, and view
finished results.
In order to set up your IP/DNS, please do the following. Click Wizard > Basic > Step 1 IP to access this
screen.
MAC Address This field displays the MAC address of the discovered device.
IP Address This field displays the IP address of an internal interface on the discovered device that
first received an ZDP discovery request from the ZON utility.
System Name This field displays the system name of the discovered device.
Location This field displays where the discovered device is.
Status This field displays whether changes to the discovered device have been done
successfully. As the Switch does not support IP Configuration, Renew IP address and
Flash Locator LED, this field displays “Update failed”, “Not support Renew IP address”
and “Not support Flash Locator LED” respectively.
NCC Discovery This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it’s enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it’ll go into
the Nebula cloud management mode.
Serial Number Enter the admin password of the discovered device to display its serial number.
Hardware Version This field displays the hardware version of the discovered device.
Table 8 ZON Utility Fields
LABEL DESCRIPTION
To Next Page
Loading...
