Chapter 36 Access Control
XS1930 Series User’s Guide
294
The following table describes the labels in this screen.
36.3 Configuring SNMP
Use this screen to configure your SNMP settings.
Click Management > Access Control > SNMP to view the screen as shown.
Figure 214 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 151 Management > Access Control
LABEL DESCRIPTION
SNMP Click this link to configure your SNMP settings.
Logins Click this link to assign which users can access the Switch via web configurator at any one
time.
Service Access
Control
Click this link to decide what services you may use to access the Switch.
Remote
Management
Click this link to specify a group of one or more “trusted computers” from which an
administrator may use a service to manage the Switch.
Table 152 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or both
(v3v2c).
SNMP version 2c is backwards compatible with SNMP version 1.
To Next Page
Loading...
