ZyXEL Communications XS1930 Series - The Web Configurator Layout

Chapter 4 The Web Configurator
XS1930 Series User’s Guide
57
Figure 40 Wizard > QoS > QoS Setting
Each field is described in the following table.
4.5 The Web Configurator Layout
This guide uses XS1930-12HP screens as an example. The screen may vary slightly for different models.
The following figure shows the navigating components of a web configurator screen.
Table 17 Wizard > QoS > QoS Setting
LABEL DESCRIPTION
QoS Setting
Select all ports Select all ports to apply settings on all ports.
You can select a port by clicking it.
High Select ports and click the High button, so they will have high priority.
The port’s IEEE 802.1p priority level will be set to 5. Use Basic Setting > Port Setup to adjust the
value.
Medium Select ports and click the Medium button and, so they will have medium priority.
The port’s IEEE 802.1p priority level will be set to 3. Use Basic Setting > Port Setup to adjust the
value.
Low Select ports and click the Low button, so they will have low priority.
The port’s IEEE 802.1p priority level will be set to 1. Use Basic Setting > Port Setup to adjust the
value.
Finish Review the information and click Finish to create the task.
Cancel Click Cancel to exit this screen without saving.