ZyXEL Communications XS1930 Series - 5.2 Configuring Switch Management IP Address

Chapter 5 Initial Setup Example
XS1930 Series User’s Guide
66
Figure 45 Initial Setup Network Example: Port VID
1 Click Advanced Applications > VLAN >
VLAN Configuration in the navigation
panel. Then click the VLAN Port Setup
link.
2 Enter 2 in the PVID field for port 1 and
click Apply to save your changes back
to the run-time memory. Settings in the
run-time memory are lost when the
Switch’s power is turned off.
5.2 Configuring Switch Management IP Address
If the Switch fails to obtain an IP address from a DHCP server, the Switch will use 192.168.1.1 as the
management IP address. You can configure another IP address in a different subnet for management
purposes. The following figure shows an example.