Chapter 32 Static Route
XS1930 Series User’s Guide
259
32.2 Static Routing
Click IP Application > Static Routing in the navigation panel to display the screen as shown. Click the link
next to IPv4 Static Route to open a screen where you can create IPv4 static routing rules. Click the link
next to IPv6 Static Route to open a screen where you can create IPv6 static routing rules.
Figure 183 IP Application > Static Routing
32.3 IPv4 Static Route
Click the link next to IPv4 Static Route in the IP Application > Static Routing screen to display the screen
as shown.
Figure 184 IP Application > Static Routing > IPv4 Static Route
The following table describes the related labels you use to create a static route.
Table 130 IP Application > Static Routing > IPv4 Static Route
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
Destination IP
Address
This parameter specifies the IP network address of the final destination.
IP Subnet Mask Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet mask
field to force the network number to be identical to the host ID.
To Next Page
Loading...
