ZyXEL Communications XS1930 Series - Page 189

Chapter 22 Policy Rule
XS1930 Series User’s Guide
189
Figure 135 Advanced Application > Policy Rule
The following table describes the labels in this screen.
Table 88 Advanced Application > Policy Rule
LABEL DESCRIPTION
Active Select this option to enable the policy.
Name Enter a descriptive name for identification purposes.
Classifier(s) This field displays the active classifier(s) you configure in the Classifier screen.
Select the classifier(s) to which this policy rule applies. To select more than one classifier, press
[SHIFT] and select the choices at the same time.
Parameters
Set the fields below for this policy. You only have to set the field(s) that is related to the action(s) you configure in
the Action field.
General
VLAN ID Specify a VLAN ID.
Egress Port Type the number of an outgoing port.
Priority Specify a priority level.
Rate Limit You can configure the desired bandwidth available to a traffic flow. Traffic that exceeds the
maximum bandwidth allocated (in cases where the network is congested) is called out-of-profile
traffic.
Bandwidth Specify the bandwidth in kilobit per second (kbps). Enter a number between 1 and 1000000.