ZyXEL Communications XS1930 Series - Page 41

Chapter 4 The Web Configurator
XS1930 Series User’s Guide
41
Figure 22 Web Configurator: Message
You may also access this screen at Basic Setting > Cloud Management > Nebula Switch Registration.
6 The Wizard screen will appear after logging into the Switch. You can use the Wizard screen to configure
the Switch’s IP, login password, SNMP community, link aggregation, and so on. See Section 4.4 on page
48 for more information on the Wizard screen. When you finish configuring the settings, you can click the
Apply button to make the settings take effect. Check the screens to see if the settings are applied, and
click the Save button in the top to save your configuration into the Switch’s nonvolatile memory. You
can also just click the Apply & Save button to make the settings takes effect, and save your
configuration into the Switch’s nonvolatile memory at once.
Note: Once you click the Apply or Apply & Save button, the settings configured in the Wizard
screen will overwrite the existing settings.
Otherwise, click the Exit button. You can select the Ignore this wizard next time check box and click
Apply if you don’t want the Wizard screen to appear the next time you log in. If you want to open the
Wizard screen later, click the Wizard icon in the upper right hand corner of the web configurator.