Chapter 7 Status
XS1930 Series User’s Guide
76
This screen shows the neighboring device first recognized on an Ethernet port of the Switch. Device
information is displayed in gray when the neighboring device is offline.
Click Status > Neighbor to see the following screen.
Figure 54 Status > Neighbor
The following table describes the fields in the above screen.
Table 21 Status > Neighbor
LABEL DESCRIPTION
Port This shows the port of the Switch, on which the neighboring device is discovered.
Port Name This shows the port description of the Switch.
Link This shows the speed (either 100M for 100Mbps, 1G for 1 Gbps, 2.5G for 2.5 Gbps, 5G for 5
Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex or H for half). This field displays
Down if the port is not connected to any device.
PoE Draw (W) This shows the consumption that the neighboring device connected to this port draws from
the Switch. This allows you to plan and use within the power budget of the Switch.
System Name This shows the system name of the neighbor device.
IP This shows the IP address of the neighbor device. The IP address is a hyper link that you can
click to log into and manage the neighbor device through its web configurator.
PWR Cycle Click the Cycle button to turn OFF the power of the neighboring device and turn it back
ON again. A count down button (from 5 to 0) starts.
Note: The Cycle button is clickable only when the neighboring device is a
powered device (PD) and able to receive power from the Switch.
Reset to Default Click the Reset button to reset the neighboring device to its factory default settings. A
warning message “Are you sure you want to load factory default?” appears, prompting
you to confirm the action. After confirming the action a count down button (from 5 to 0)
starts.
Note:
• The Switch must be a Power Sourcing Equipment (PSE) and the neighboring device is a
powered device (PD).
• If multiple neighboring devices use the same port, the Reset button is not available.
• You can only reset Zyxel powered devices that support the ZON utility.
To Next Page
Loading...
