3D Systems DMP Flex 350 - Remove Stored Energy from Gas Lines; Restore Equipment to Service Safely; Multi-Person Lockout;Tagout Procedure

3D Systems, Inc.
13
p/n: 15-D99, rev. C
F. For other chillers
If using another chiller, make sure it falls within these guidelines:
• Temperature inlet water: 20° +/- 1° C
• Flow: Minimum 13 l/min - maximum 25 l/min
• Max cooling power: 2.6 kW
• Max pressure: 4 bar
• 1” BSP connection
• Ensure an overpressure protection is install.
• Adhere to cooling water and additives requirements provided by 3rd party supplier.