3M MS2 User Manual

9
4.14 4041 Rear Spring Holder
Allows the addition of a second set of wire
retaining springs to the back of the 4041 MS
2
Splice Head. Used in the conversion of Super-
Mini splices to pluggable Super-Mate splices
and for cutting in Super-Mate Modules on
through cables.
4.18 4019 Check Comb
Used to detect splicing errors prior to module
crimping. Also used as a temporary module
cover in certain splicing applications.
903882
4.16 4053 Cover Removal Tool
Recommended tool for the removal of MS
2
module covers and bases.
81203
4.15 4041-2......2" Unilength Hook
4041-4......4" Unilength Hook
Attaches to all MS
2
splicing heads to facilitate
splicing in the unilength configuration.
74011
4.17 E9-BM Crimping Tool
Crimps MS
2
module bases and covers onto
connector bodies.
883640
4.20 4005-DPM/PTJ Preterminated Jumper
Assemblies
The 4005-DPM/PTJ consists of 24 AWG, PIC,
unsheathed 25-pair binder group terminated on
each end with a 4005-DPM Module. Available
in 36" (91.4 cm) or 72" (182.9 cm) lengths, the
jumpers enable fast restoration of cut or dam-
aged cables. Also used in maintenance of
Super-Mate Module splices where uninterrupted
service is required.
883640
903882
4.19 4000-D/PTJ Preterminated Jumper Assemblies
Consists of 24 AWG, PIC, unsheathed binder
group terminated on each end with a 4000-D
body/cover combination. Available in 36" (91.4
cm) or 72" (182.9 cm) lengths, the jumpers
enable fast restoration of cut or damaged cables.
903882

3M MS2 Specifications

General

Brand	3M
Model	MS2
Category	Power Tool
Language	English