DT390
5. Press Call or to make the call.
6.5 Dial a Name from the Central Phonebook
1. Enter Contacts.
2. Select Central phonebook.
3. Select Search by name.
4. Enter the first/last name and press Search.
5. Press Call or
to make the call.
6.6 Write Text
When writing text messages and adding/editing or searching for names in the
Phonebook, the keys 0 to 9, *, or # can be used. The first character entered will
be an upper level character followed by lower level characters unless the *-key
is pressed before entering the character.
When pressing a key, the first available character on that specific key is
displayed. To get the following characters, press the key repeatedly. Key 0 and
1 contain special characters. The marked character is selected after a time-out
(3 seconds) or when another key i s pressed.
Pressing key 1 adds space between the characters and pressing the *-key
switches between upper and lower case (not applicable in the System
Phonebook). The first character entered in a message, or when adding/editing
a name in the phonebook, will be an upper level character followed by lower
level characters unless the *-key is pressed before entering the character.
Example (to write Smith):
7777Press for S.
6 Press for m.
4 4 4 Press for i.
8 Press for t.
4 4 Press for h.
Example 1
Control keys
While entering a name or a number, you can use the following keys for control
and navigation:
1. Press the left navigation key to move to the left.
Note: Moves to the beginning of the text if held longer.
34
1424-EN LZT 103 091 Uen A1 2008-10-27
To Next Page
Loading...
