DT390
1. Press *2 1# to activate the diversion.
2. Wait for the verification tone.
3. Press
to finish the procedure.
You can make outgoing calls as usual. A special dial tone and the display
info reminds you that a Call Forwarding is active.
Cancel Diversion
1. Press #2 1#
to cancel diversion.
2. Wait for the verification tone.
3. Press
to finish the procedure.
New incoming calls will be signalled on y our phone again.
9.5 Diversion when Charging
When the cordless phone is placed in the charger, incoming calls will be
diverted to a pre-programmed diversion address (same address as used for
the feature Fixed Diversion).
Activate
1. Press Menu.
2. Select the Settings tab.
3. Select the menu item In charger.
The following options are available:
•Noaction
• Switch off
• Redirect
4. Select Redirect and press Back.
Note: If the cordless phone is logged on as secondary phone in a
Tandem configuration and placed in the charger, incoming calls will
further on be presented on the primary phone and not be diverted.
Deactivate
44
1424-EN LZT 103 091 Uen A1 2008-10-27
To Next Page
Loading...
