Mailbox System
You can be notified in two different ways (depending on the programming of
the system):
• Notification with mailbox access: You acknowledge the notification through
your password (has to differ from the default value 0000). See Section
12.8 on page 59 to select a new password. You have full access to the
mailbox system.
• Notification without mailbox access: You get a short voice announcement
informing you that someone has left a message for you. You acknowledge
the notification by pressing any key. You have to call back the mailbox
system to retrieve the message.
Note: If you do not acknowledge the notification within the pre-programmed
time, the connection is cancelled and repeated later (ask the system
administrator for the programmed number of notification attempts).
1. Access the mailbox. (See Section 12.3 on page 55)
Listen and follow the voice announcements in the main menu.
2. Select 4 to set up outcall notification.
Listen and follow the dedicated voice announcements.
You can program the external notification number, the notification time
and activate/deactivate the function. The external number (including the
digit(s) for external line access) can consist of up to 24 digits. The time is
entered in 24h-format, for example. 2030 for half past eight with values
automatically set to even quarters, that is to say 2013 will be 2015.
Note: The notification number and time must be programmed before you
activate the notification.
3. Press
to finish the procedure.
12.8 Change Password
Change the password through your mailbox
1. Access the mailbox.
(See Section 12.3 on page 55)
2. Select 5 to change the password.
Listen and follow the dedicated voice announcements.
3. Press
to finish the procedure.
59
1424-EN LZT 103 091 Uen A1 2008-10-27
To Next Page
Loading...
