Installing MX-ONE
Figure 35 Energy Hazard Warning Label
When adding a rectifier module (BML 351 056) always start from the left most
position in the subrack. Flip down the handle and pull out the dummy. Place the
module into the correct mounting position and slide carefully the module until it
contacts the interface connection at the rear of the shelf see Figure 39. When
the rectifier reaches the backplane, flip up the handle to secure the module.
Figure 36 Adding a Rectifier Module
4.6.3 Installing the AC/DC Unit Shelves 230 V
Use the following material set to install the AC/DC shelves and the AC/DC unit:
50
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...