Installing MX-ONE
Parts from this mounting set are used at a later installation stage, leave the
remaining parts at hand.
4.8.3 Mounting the Front Air Plate in Subrack A
To prepare subrack A for installation in the cabinet, first mount front and rear
air plates in the subrack as follows:
Figure 44 Mounting the Front Air Plate in Subrack A
1 Place subrack A in an upside-down position on a steady work surface.
2 Insert the front air plate (H) to the slot against the cable chute, Page 60
3 Fasten the front air plate to the subrack by using two screws (F), Page 60
Parts from this mounting set are used at a later installation stage, leave the
remaining parts at hand.
60
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...
